Needle bar height Adjustment

BROTHER SINGLE NEEDLE LOCKSTICH

BROTHER SINGLE NEEDLE

Adjusting the needle bar height

Reference line (a), which is the second line from the bottom of the needle bar (1)(fourth line from the bottom when using a DA x 1 needle) should be aligned with the lower edge of the needle bar bush D (2) as shown in the illustration when the needle bar (1) is at its lowest position.

  1. Turn the machine pulley to set the needle bar (1) to its lowest position.
  2. Remove the oil cap (3).
  3. Loosen the screw (4) and then move the needle bar (1) up or down to adjust its position.
  4. Securely tighten the screw (4).
  5. Replace the oil cap (3).

Comments

dfgdfsgdfgfdg

You may also like...