ERROR History for Brother home sewing machine

Error Code Cause of Probable Solution

E1

The foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) and the reverse/reinforcement stitch button was pressed while the presser foot is raised. Lower the presser foot lever before continuing the operation.

E2

A stitch other than the buttonhole or bar tack stitch was selected and the foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) while the buttonhole lever is lowered. Raise the buttonhole lever before continuing the operation.

E3

The buttonhole or bar tack stitch was selected and the foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) while the buttonhole lever is raised. Lower the buttonhole lever before continuing the operation.

E4

The reverse/reinforcement stitch button or needle position button was pressed while the bobbin winder shaft is moved to the right. Move the bobbin winder shaft to the left before continuing the operation.

E5

The start/stop button was pressed while the foot controller was connected. Disconnect the foot controller, and then press the start/stop button. Otherwise, operate the machine by using the foot controller.

E6

The motor locked up because the thread is tangled. Remove the tangled thread before continuing the operation.

No Power

Main Power supply missing Check on/off switch. Check fuse of power circuit board
dfgdfsgdfgfdg

You may also like...